We had 1,100 pieces of these custom metric dacromet coated u-bolts produced using 42CrMo material with heat treat hardening. The part was originally designed to be made using 17-4PH stainless steel material but a number of attempts resulted in multiple failures during bending – the material was too hard and repeatedly snapped as the tool […]

These are 8-32 custom V bolts we had domestically produced for our customer. Initially 12 pieces were run for prototype testing purposes prior to full production order. The inside length to the bottom of the V is 1″ and .625″ between the legs. 0.6″ of 8-32 thread is incorporated on both legs. One thing to […]

These custom small diameter u-bolts are the more unusual u bolts we have supplied over the years – the one and only time we had to get fully threaded u-bolts manufactured. Typically only a partial length of each leg is threaded, whether cut threads or rolled, but in this case our customer specifically requested a […]

These are 9 different custom large plain steel u-bolts we supplied our customer in the Kansas City, MO area. Quantities ranged across the nine different sizes but all shared the 3/4-10 diameter and thread pitch, as well as the plain A36 steel material. The largest size pictured with Leonid here measured 42 inches on the […]

These are custom T304 stainless u-bolts we supplied our customer in two different dimensional variants: the smaller round u-bolts measure 3-1/2″ for the inside width and 6-1/2″ for the inside depth while the larger version measures 6-5/8″ at the inside width and 10″ for the inside depth. 130 pieces of the larger u-bolts and 80 […]

These are custom large 316 stainless u-bolts we supplied our customer in San Diego. They specialize in waterworks related construction and specifically needed 316 stainless steel material with a fast turnaround. We were able to ship the parts within 4 days of order confirmation. 1/2″ diameter bar stock was used with 2 inches of coarse […]

Jose, aka “Chef”, is holding up two custom large HDG U-bolts we had produced for our custom in Rock Hill, South Carolina. Time was of the essence and we were able to ship the parts within approx 7 business days of order with 4 galvanized heavy hex nuts per u-bolt. 1″ diameter A36 material was […]

This is one of our small custom plain steel u-bolts made domestically to our customer’s drawing and tolerances. Only 20 pieces were required and 5/16-18 rolled thread was requested with a .06 X 45 degree chamfer requested and undersized first two threads. The center to center dimension was set at .81″, inside length at 1.38″ […]